بیش از 10 سال ما به شرکت ها کمک می کنیم تا به اهداف مالی و تجاری خود برسند. اونوم یک آژانس سئو محور مبتنی بر ارزش گذاری است.

آخرین خبرها
اطلاعات تماس
Twitter Facebook-f Pinterest Instagram
Specialized repairs of hydraulic presses

Berardan Sadeghi Machinery, equipped with an experienced team with specialized tools, is ready to provide specialized repair services for hydraulic presses.

Get help from our consultants for more information.

General instructions for setting up and installing and using and maintaining the hydraulic press machine:

A: The conditions of the installation platform and installation of the press machine

1. The location of the press machine must have a concrete foundation at least 30 cm high.
2. The surface of the place of establishment must not have any slope.
3. The dumper hole must be installed inside the foundation.
4. No tiles should be placed between the foundation and the press.
5. The hydraulic unit must be roofed and covered on 3 sides with a suitable space for service.

B: Device usage program

1. It is mandatory to turn on the engine of the device to heat the oil before charging the batteries for 15 minutes at the beginning of each day.
2. A general inspection of the parts of the press, including screws, blades, trunk, end and initial connections of jacks, and inspection of microswitches or inductive sensors to ensure that they are healthy should be done every day.
3. Inspection of the tank oil should be done when all the jacks are forward.
4. Make sure that the pressure is not higher than the limit (side jack 180 bar, upper jack 170 bar and twin jacks 200 bar).
5. If necessary, perform repeated wrenching of the side check in the part connected to the body of the press.
6. Inspect all connections for lack of lubrication at the beginning of each work shift.
8. When using remote control or piano board chassis, preferably use automatic cycle.

C: Device maintenance program

1. Apply grease weekly.
2. Wrenching of all parts on a weekly basis 3- Cleaning the oil filters on a monthly basis.
4- Cleaning under the dumper frequently.
5- Not hitting the press during charging.
6- a maximum of 8 hours of daily work with the device.

D: Warnings

1. When the pressing operation starts and the machine door is closed, the manpower is not allowed to approach the door and the blades.
2. During the visit and service of the press machine, the machine must be turned off.
3. During the pressing operation, the operator is obliged to ensure the correct placement of the locks in the corresponding place on the door of the pressing machine.